Anyone experienced on hooking up VR4 loom to the cordia dash? I wanna know where i am hooking up the tacho and oil presure guages to...

Way

_________________
()...()
(o o)
/ ( ..)
/ ""
"All throttle, no bottle"
AC GSR - Worked 4G62BT (Original 510DIA)-SOLD-
AC GSL - VR4 Turbo (Slowdia NO2) -SOLD-
Honda Civic - H22aT transplant -SOLD
180sx - RB'd -SOLD-
R32 - RB Powered -SOLD-
Honda Civic vtiR, vtec yo!

i'm trying to figure this one out as well
i've got the tacho running i'll take some pictures of how it wired
my oil pressure guage "works" i think i need to put the cordia oil pressure sensor on (when there is no oil pressure the guage rises staight o the top) i assume this is because the galant only has an oil light

_________________
http://www.pbase.com/mrbishi

CORDIA BUILD BELOW
https://www.youtube.com/channel/UCuE4NT ... 954epi0wBw

Yeah an oil pressure light sender doesn't work, only does somthing at little pressure...

The oil pressure guage sender is pretty large, has a bellow type arangment I think, and you will need to install this in exchange for the small light sender....

Easiest to use some multi-grips on it I think, but when I was doing my engine conversion, I lost mine so you can use insted a G clamp.... hehe Rangi mods...

Another dodgy method of doing things is insted of using vice grips if you don't have any, use some pliers and a g clamp on the pliers until they are bending severly...

or get the right bloody sized socket on it...???.....

If you need to know factory wiring colours connectors etc pm me nad i'll give you the details...

or go buy all autometer mechanical gauges and remove the dash..
dylan

_________________
Is there anything better in life than boost...??

It's prett wierd thing, not really socket styles...
The sochet you would have top use would be MASSIVE, about a 30 perhaps?