Cordia Forum https://www.cordiapower.com/forum/ |
|
Wiring help https://www.cordiapower.com/forum/viewtopic.php?f=4&t=19364 |
Page 1 of 1 |
Author: | sleeping giant [ 03 Jan 2017, 09:56 ] |
Post subject: | Wiring help |
Hi Guys , can anyone help out with a wiring diagram for a AB cordia turbo and also Jap spec e39a galant vr4 I am trying to wire up the ignition correctly this time. My original cordia vr4 would have the fuel pump start from acc, and then wouldn't turn off until 2 clicks back on the key. Basically if i ever had a prang it would of kept powering the pump until key turned or pump loses power. Because i'm new to this electrical side of things I was hoping to get both diagrams to help me through it, unless someone can tell me basically how to get a e39a galant vr4 computer wired into the AB 85 cordia turbo ignition correctly. Thanks Guys. |
Author: | fernandothecarguy [ 03 Jan 2017, 13:30 ] |
Post subject: | Re: Wiring help |
Stock ecu I think would hard , Best to check with Galante forum, I did microtec mt8 but I had instructions manual Anyway good luck |
Author: | Bitza [ 03 Jan 2017, 16:54 ] |
Post subject: | Re: Wiring help |
viewtopic.php?f=14&t=16266 Email me if you need the clear version..............basically strip the Galant loom for injection and splice it into the cordia wiring, use all of the cordia relays, black/white wire is power 12 Volt. |
Page 1 of 1 | All times are UTC + 10 hours [ DST ] |
Powered by phpBB® Forum Software © phpBB Group https://www.phpbb.com/ |