Cordia Forum
https://www.cordiapower.com/forum/

No gears
https://www.cordiapower.com/forum/viewtopic.php?f=4&t=17913		 Page 1 of 1
Author:  blucordia85+ [ 06 Mar 2016, 08:54 ]
Post subject:  No gears
Hi all just hoping someone can help me out.. Just did a 4g63 swap and all has gone well except no gears.. It sounds like it's changing gear but nothing happening! I know it worked before I put it in so hoping it's something simple..
Author:  Bitza [ 06 Mar 2016, 12:37 ]
Post subject:  Re: No gears
Sounds like your box has gone into neutral, did you connect the solenoid valve up to the inlet manifold for over drive?

If you have you may have your vacc lines around the wrong way.

Does it look like this?

Image

Have you connected all of the wiring harness?
Author:  blucordia85+ [ 06 Mar 2016, 15:36 ]
Post subject:  Re: No gears
Okay so I've checked vacation lines and wiring, all good there.. The vacuum solenoid was pushed in so I did that and got gears... Hooray... Until I try and put it in gear while it's running and no go.. So tried to bleed some more and doesn't fix.. So close to driving it but yet so far lol
So just changed slave cylinder to another one I had along with the hard line connecting it and finally it all works :-) hady first drive and was surprised with another problem, the steering is all screwed up lol gone from power steering to manual and the tie rids weren't aligned properly... So fix that and actually had a proper drive finally.. So far so good apart from a few little issues..
Author:  Bitza [ 06 Mar 2016, 17:15 ]
Post subject:  Re: No gears
So your problem is fixed?
Author:  blucordia85+ [ 06 Mar 2016, 19:04 ]
Post subject:  Re: No gears
Yeah issue sorted thankyou.. Appreciate your time..
Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/