Cordia Forum
https://www.cordiapower.com/forum/

Sticky, : The parts interchange / part number thread
https://www.cordiapower.com/forum/viewtopic.php?f=4&t=16553
Page 1 of 1

Author:  ssb2005 [ 09 Jul 2011, 18:36 ]
Post subject:  Sticky, : The parts interchange / part number thread

Please sticky

Seeing bits off the shelf for the cordia are getting harder to come by i thought i would start a thread listing what other parts from other cars fit into the cordia. Post additions below and i will edit them into this post. please post only if your adding something so it doesnt get clogged up.
I have been out of the game for a while so you will need to refresh my memory :mrgreen:


Supsension]
VR-4 and early evo struts, strut top needs to be modified.
Koni insert part number 8640-1108 for fronts (no longer made)

Springs
King standard and low Std (KCFS15/ KHRL07) Low (KCFL15 / KMFL06)
Lovells, Standard and low
Pedders, Standard and low

Front Struts
KYB EUROPE/US Part # 634001 (Kyb premium)
KYB Part # 334001 (Kyb excel g)
Monroe 35-0164 GT Gas
Monroe 37-0164 Sensatrac
3905 Pedders Sealed Strut (touring black)
8905 Pedders Sealed Strut (comfort gas)
Gabriel Ultra gas # G55531
SACHS 110-249 - Super touring twin tube, - To be discontinued
BOGE 30-A24-A - BOGE Automatic

Part No's match
Mitsubishi Magna 1985-91 TM TN TP Sedan and Wagon
Mitsubishi Nimbus 1984-87 UA & UB
Mitsubishi Nimbus 1987-92 UC
Mitsubishi Sigma 1983-87 FWD ?????


Rear Shocks
SACHS Part # 030274
SACHS 312 037
KYB Gas A Just Part # KG4192
BOGE Part # 30E66A or 30-E66-A
KYB Part # 343183 (KYB Excel G)
8083 Pedders Shock Absorber
Monroe 15-0147+ (Gt gas)
Monroe 17-0147+ (Sensatrac)
Gabriel Ultra gas # 69689

Supposed to match following cars, Mitsi Colt, 86-94 Huyundai Excel, 91-95 Huyundai S-Coupe

OEM numbers for shocks
http://infodozer.com/catalogs/tokico/se ... MITSUBISHI

Whiteline
KCA412 Front Camber adj bolt kit - 12mm
W81075 Front Radius rod - to chassis bushing - GSL ONLY

K-Mac still do Strut tops and swaybars (so they say)
http://www.k-mac.com/index.html


Steering

Repco Part No's
CORDIA
CORDIA AA / AB 04/83-11/85
BALL JOINT LOWER TBJ285
RACK END LH & RH MANUAL STEERING TRE856
RACK END LH & RH POWER STEERING TRE890
TIE ROD END OUTER LH & RH TTE615R

CORDIA AC 12/85-07/89
BALL JOINT LOWER TBJ285
RACK END LH & RH POWER STEERING TRE88

Pedders
PTE615R Pedders Tie Rod End
PBJ285 Pedders Ball Joint

Pedders Bushes
EP1256 Urethane Radius Rod Bush (4 PKT)
EP1448 Urethane Radius Rod Bush (4 PKT)
EP3360 Urethane Swaybar Link/ Shock Bush (4 PKT)
4359 Bump Stop & Boot Kit

Brakes
Galant VR-4 (front)
Pajero fronts, From same year as vr-4??
TN-TP Magna Brake systems
3000GT (requires spacer to clear most rims) need minimum 17 inch rim.


Brake service (AA/AB)
BOJB8479 PBR Brake Caliper Piston
BOK2167S PBR Brake Caliper Recondition Kit
BOJB1680 PBR Brake Master Cylinder Assembly
BOK8204X PBR Brake Master Cylinder Recondition Kit

Fuel system
Fuel Pumps
Return system in the cordia is good so you can upgrade the pump with out any dramas
VL Turbo fuel pump (bosch 070)
Starion fuel pump
(Walbro 255) Part Numbers GSL-392 255 LPH Fuel Pump and 400-952 installation kit.
geewiz wrote:
Bosch 910 fits straight in as fuel pump ;) cordia wheel nut for the cap nut aswell if one cannot be found ;) I just faced the edge down in a laithe to create a flat surface for copper crush washer :)



Throttle body repair kit.
STANDARD MOTOR PRODUCTS Part # 1529 (listed for 1.8 turbo)
Alternate/OEM Part Number(s): MD608707, MD608906, MD608907, MD608932, MD614110, MD614116

Injectors
GB REMANUFACTURING Part # 84117119 (AB/AC)

Fuel filler hose part no - MB433049 (from filler to tank - rubber)
Can be found on Express van / starwagon

Manifolds
Sonata Multipoint manifold
also L300 van manifold / plenum
XF falcon throttlebody for MPI manifold and VR-4 Blue top injectors

Transmission
LSD from Mitsubishi Mirage Cup
KAAZ LSD can be modified to fit

Timken rebuild kits
G/Box Year / eng Kit no
KM165 83-88 1.8L TRK-FC110
KM162 83-88 1.8L TRK-FC110
KM163 83-88 2.0L TRK-FM170
KM163 6/83-11/86 1.8L Turbo TRK-FM170
KM166 83-88 2.0L TRK-FM170

CV Shafts
410031R Pedders CV - Shafts (New)
410031L Pedders CV - Shafts (New)
410026R Pedders CV - Shafts (New)
410092R Pedders CV - Shafts (New)

Clutch
Exedy Part No's
http://www.infodozer.com/catalogs/exedy/search.php?model=CORDIA

Lucas clutch
http://www.infodozer.com/catalogs/lucas_clutch/search.php?model=CORDIA%20(A21_A)&maker=MITSUBISHI



Engine components
4G62 SOHC
Rods / Crank from Pre 1993 4g63's should fit.

Pistons.
Try ordering from these guys in NZ
http://www.bowdenengineparts.co.nz/pdf/pistons.pdf

For Forged is custom only, unless someone advised me otherwise

4G63 SOHC
Rods / Crank / pistons from all Pre 1993 4g63's should fit. 0.4 is lost from compression ratio using 4 valve pistons in 2 valve motor.

Keith Black Silv-o-lite pistons with 3 valve reliefs. Part no # 3217
Try Arias, Wiseco, Eagle, Manley, Venolia, JE etc for forged.

Balance shaft eliminator kit
http://www.ffwdconnection.com/bsek.shtml

SOHC Cams
http://www.camtechcams.com.au/mits_4cyl_4g624g63.html
http://www.wadecams.com/
http://www.gtpumps.com.au/ - Stock camtech

SOHC to DOHC head swap tutorial
http://projectzerog.com/sohc-dohc.shtml



2.3L "stroker" motor (2.0L Block, 2.4L crank)
Larger displacement
Stock Block / Bore
Lower Redline Than Stock
Can use stock 150mm rods / 6mm offset pin stroker pistons

2.1L "destroker" motor (2.4L Block, 2.0L crank)
Slightly Larger displacement
Much Higher Redline than stock (11,000rpm)
Need strong 162mm rods / 6mm offset pin stroker pistons



Exterior

Bodykit
http://www.fibremaster.com.au/mitsubishi.htm
MICOFS-201 Front spoiler. $220.00
MICOSS-201 Side skirts $280.00
MICORS-201 Rear skirt. $240.00
MICOBS-21 Bonnet scoop $160.00

http://classicgarage.com/corsidskirse.html
Mitsubishi Cordia - Side Skirts with Spats VT-13044 Retail price: $429.98 classicgarage.com: $129.96



Websites to try
Parts
http://www.supercheapauto.com.au/parts_guide/default.aspx
http://www.rockauto.com/catalog/raframecatalog.php
http://www.ffwdconnection.com/
http://www.summitracing.com/

Manuals / Other
4G63 Manual
http://www.austarion.com/tech/4g63.pdf

http://www.turbocreations.com/cordiatur ... sions.html

Author:  JiMi [ 09 Jul 2011, 19:29 ]
Post subject:  Re: Sticky, : The parts interchange / part number thread

stickied

Author:  11scordia [ 20 Aug 2011, 18:19 ]
Post subject:  Re: Sticky, : The parts interchange / part number thread

what other headgaskets will fit i want a triple plate steel head gasket

Author:  geewiz [ 20 Aug 2011, 19:58 ]
Post subject:  Re: Sticky, : The parts interchange / part number thread

ssb2005 wrote:
Please sticky

Seeing bits off the shelf for the cordia are getting harder to come by i thought i would start a thread listing what other parts from other cars fit into the cordia. Post additions below and i will edit them into this post. please post only if your adding something so it doesnt get clogged up.
I have been out of the game for a while so you will need to refresh my memory :mrgreen:


Supsension
VR-4 and early evo struts, strut top needs to be modified.
Koni insert part number 8640-1108 for fronts (no longer made)

K-Mac still do Strut tops and swaybars (so they say)

Brakes
So 3000gt brakes bolt straight on do they
Galant VR-4 (front)
Pajero fronts, From same year as vr-4??
TN-TP Magna Brake systems
3000GT (requires spacer to clear most rims) need minimum 17 inch rim.

Fuel system
VL Turbo fuel pump
Starion fuel pump

Manifolds
Sonata Multipoint manifold
also alledgedly L300 van manifold / plenum
XF falcon throttlebody for MPI manifold anf VR-4 Blue top injectors

Transmission
LSD from Mitsubishi Mirage Cup
KAAZ LSD can be modified to fit.


So 3000gt brakes bolt straight on do they ?
I would suggest maybe makeing notes of parts that need a fair bit of mods to make fit and parts that bolt straight up.
Bosch 910 fits straight in as fuel pump ;) cordia wheel nut for the cap nut aswell if one cannot be found ;) I just faced the edge down in a laithe to create a flat surface for copper crush washer :)

Author:  ssb2005 [ 31 May 2012, 20:27 ]
Post subject:  Re: Sticky, : The parts interchange / part number thread

Updated

Author:  S1VART [ 02 Jun 2012, 06:50 ]
Post subject:  Re: Sticky, : The parts interchange / part number thread

Verada KS XI front front brake calipers are the same as VR4 also and the lines are the same as the cordia too

the balance shaft eliminator kit is out of a Lancer CB GSR 1.6 ( 4G61 ) DOHC

Author:  4cylturb [ 05 Jul 2012, 21:29 ]
Post subject:  Re: Sticky, : The parts interchange / part number thread

KYB rear shocks (oil NOT gas) part #443087

Also the KYB front struts part #643001 (KYB premium) are also oil and NOT gas

http://www.docstoc.com/docs/96164775/kyb_japan_2011

Page 1 of 1 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/