Hey, I have always wanted an evo front bar for my Cordz, the only reason I have been reluctant about it is cos I have had a stack in the past and when the panel beater straightened it all up he told me its not perfectly straight, its probably still out by about 2 degrees or so. The replacement panels that I put on needed a little bit of convincing to get them on so I was in doubt that a custome evo front would fit on properly, is there anywhere in Melbourne that does these so I can go out there and have them measure it all up for me?

_________________
~8v 4G63 AC GSR
FMIC
2.5" exhaust
K&N air filter
Modified AFM
Re-Graphed dizzy
rear KYB struts
110.6wkw @ 13.3psi

~1999 Honda VFR800

Got to Team Jet Speed: 12 Whiteside Rd Clayton South 03 9548 8828

These guys should be able to help you out finding someone that does them, or if not can do one for you probs

Steve

_________________
yeah im startin to hate the fact i have this
hole in my pocket, its called a Cordia!
I'm not totally sure wat it is as it acts like
a gf but doesnt talk back when you give it shit

Cool, hope they are open Saturday mornings, what are they exactly Carbon fibre moulders or something?

_________________
~8v 4G63 AC GSR
FMIC
2.5" exhaust
K&N air filter
Modified AFM
Re-Graphed dizzy
rear KYB struts
110.6wkw @ 13.3psi

~1999 Honda VFR800

Team jetspeed do anythin from custom bars to off the shelf bars, they can do one off's as well it will cost but hey if it is the only one then its worth it

Give them a call and ask when they are open

_________________
yeah im startin to hate the fact i have this
hole in my pocket, its called a Cordia!
I'm not totally sure wat it is as it acts like
a gf but doesnt talk back when you give it shit