Cordia Forum
https://www.cordiapower.com/forum/

Stuff
https://www.cordiapower.com/forum/viewtopic.php?f=12&t=17978
Page 3 of 3

Author:  Bitza [ 29 Jun 2016, 14:49 ]
Post subject:  Re: Stuff

They are different, check out the top left hand corner.

Author:  fernandothecarguy [ 29 Jun 2016, 20:54 ]
Post subject:  Re: Stuff

i see it :D

Author:  Bitza [ 23 Jul 2016, 17:57 ]
Post subject:  Re: Stuff

Hey guys,
Finally got around to completing the lash adjuster conversion for the 4G62..........so good, no more "tick" from the manual rockers which are a pain in the ass to adjust.

Just make sure you "prime" the adjusters before installation.

https://youtu.be/-tmk9mZm8iQ

Author:  TRQ-STR [ 24 Jul 2016, 11:25 ]
Post subject:  Re: Stuff

that's awesome man, it's so quiet!

Author:  4cylturb [ 25 Jul 2016, 10:57 ]
Post subject:  Re: Stuff

Nice upgrade Andrew. That engine bay is a work of art. I doubt they looked that good straight out of the factory.

Author:  Bitza [ 25 Jul 2016, 12:55 ]
Post subject:  Re: Stuff

Thanks Simon, let's not forget the paint in the engine bay is over 3 years old.

Author:  fernandothecarguy [ 29 Jul 2016, 10:01 ]
Post subject:  Re: Stuff

nice sounds and looks great nice job.
whats next?

Author:  Tomica93 [ 02 Aug 2016, 18:34 ]
Post subject:  Re: Stuff

by priming you mean to put the wire in the adjusters, to put all the oil out? so they primed itself at cranking, and self adjusted

Author:  Bitza [ 02 Aug 2016, 18:49 ]
Post subject:  Re: Stuff

Yes, you need to submerge the adjusters in clean oil and use the wire to remove all of the air from the check valve..........I let them sit in the oil for a couple of days and re-tested, no leak down.

If you put them in dry you'll have a hell of a time trying to get oil into cylinders 3 and 4.

Author:  Wexx [ 07 Jul 2017, 22:52 ]
Post subject:  Re: Stuff

Was looking at the intake manifold setup (multipoint) and I noticed a few differences between Oz 62's and US 62's. My AC has a cast iron timing wheel for the cam, and I have non-roller hydraulic rocker arms WITH jet valves (yes I am running jet valves w/manual adjustment). There seems to be allot of differences between countries for the same car.

Page 3 of 3 All times are UTC + 10 hours [ DST ]
Powered by phpBB® Forum Software © phpBB Group
https://www.phpbb.com/